MikeTV

Different combination also did not work. I am pinging fine. Unsure if I need to install additional DAQFactory Software. I even tried to reserve the port, bad hail mary. Is there any special mapping that is required> This is with firewall disabled and enabled. The firewall has daqfactory allowances. My last effort would be using a router and try some port method that way. Active Connections Proto Local Address Foreign Address State TCP 127.0.0.1:49153 INTEL-NUC:49674 ESTABLISHED TCP 127.0.0.1:49674 INTEL-NUC:49153 ESTABLISHED TCP 148.148.1.1:51650 148.148.1.48:1000 SYN_SENT TCP 148.148.1.1:51652 148.148.1.48:1000 SYN_SENT

I removed the other software and tried three different ports. I can try a different IP/Port Combination for sure.

Hi, I am evaluating SCADA's for a small 21 PLC project for a semiconductor manufacturer. I am having the same issues using a Mitsubishi FX3U and an ENET module set to an IP and port 5000. I started with port 5000 for Fernhill which I evaluated and it is working. Now I am on to DAQFactory. I tried a few ports and cannot connect due to port is busy. I am just trying to determine learning curve by just a quick setup and evaluating a digital I/O and an internal word. The server is a new WIN10 PRO build with WIFI turned off. IPv4 set to 192.168.1.10 and module set to 192.168.1.26 and it pings fine.