Search the Community

Showing results for tags 'canbus'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • DAQFactory
    • Alarming
    • Channels, Conversions and general data acquisition
    • Graphing
    • Logging
    • Modbus
    • Networking: web, email, FTP etc.
    • PID
    • Screen Components and User Interface
    • Sequences and scripting
    • Serial Communications
    • General DAQFactory
    • DAQFactory and the LabJack
    • DAQFactory Express
    • DAQConnect
    • DAQFactory New Feature Requests
    • The DAQFactory Guru's Articles
    • DAQFactory Newletters

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 2 results

  1. I'm connecting a PEAK Ethernet CAN gateway to DF. I have the IP and Port # set properly, and can use a sequence to format an Ethernet packet that successfully triggers a CAN frame with my data to be sent. I can observe the Ethernet packet in WireShark and see the frame go out the door properly from DF and this also shows in the Monitor window as a TX: My issue is that when the PEAK Can Gateway sends a packet back to the IP address of the PC running DF, and same port number configured in DF, I get no RX: in the Monitor window, and can't read any bytes. I can observe the packet in WireShark, so the PEAK device is sending proper packets to the right address and port. Does DF somehow listen to Ethernet traffic on a different port from what's configured? Where else can I look or test? Thank you! Mike
  2. Hi, I have an application that runs charge/discharge cycles on large battery packs. DaqFactory controls a U3HV for charger and electronic load control. I need to log data from the battery management system, which is on a CANBUS link. Has anyone setup CANBUS requests and retreived data before? The CANBUS connection is a USB to CANBUS adapter based ont the Silicon Labs CP210X USB to UART Bridge and is accessible via a COMx port. P.S.: I love DaqFactory Pierre