Search the Community

Showing results for tags 'frequency'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • DAQFactory
    • Alarming
    • Channels, Conversions and general data acquisition
    • Graphing
    • Logging
    • Modbus
    • Networking: web, email, FTP etc.
    • PID
    • Screen Components and User Interface
    • Sequences and scripting
    • Serial Communications
    • General DAQFactory
    • DAQFactory and the LabJack
    • DAQFactory Express
    • DAQConnect
    • DAQFactory New Feature Requests
    • The DAQFactory Guru's Articles
    • DAQFactory Newletters

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I am encountering erroneous frequency data when reading frequency with labjack T4. I am using DAQ factory express. Initially I encountered this in a real application, but I have been able to duplicate it in a simple .ctl, which is attached. I am reading frquency on FIO4 using the time interval method (time between rising edges). I display the result (after some calculations) and also graph the result. I am also sampling three analog channels. In experimentation I have noticed that the problem seems to go away when I delete the three analog channels. Is there any reason why the analog read operations would interfere with the read to FIO4? As far as my test setup goes, I am testing using a function generator to supply 100 Hz square wave to FIO4. I have probed it with an oscilloscope and it is a very clean signal. I do not suspect noise is any part of the problem. I have tried it on two T4 devices, and they both behaved the same way. I also attached a screenshot of the ctl file "in action." RPM is calculated from the FIO4. Basically RPM is proportional to frequency. The correct result SHOULD be 600 RPM. But often I see much higher frequencies (corresponding to shorter intervals) which are not correct. Any help or suggestions would be much appreciated. quick_freq_test_with_ADC.ctl