Search the Community

Showing results for tags 'pid'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • DAQFactory
    • Alarming
    • Channels, Conversions and general data acquisition
    • Graphing
    • Logging
    • Modbus
    • Networking: web, email, FTP etc.
    • PID
    • Screen Components and User Interface
    • Sequences and scripting
    • Serial Communications
    • General DAQFactory
    • DAQFactory and the LabJack
    • DAQFactory Express
    • DAQConnect
    • DAQFactory New Feature Requests
    • The DAQFactory Guru's Articles
    • DAQFactory Newletters

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. RLidster

    Pid And Pwm To Control Temperature

    Hi There I'm a bit of a novice and i am aware that parts of the title of this post are featured in a few others but i don't quite understand how to bring everything together with my example... My current setup is a; Temp probe (EI-1034) connected to a labjack U3 (AIN0) (channel = tempprobe) Solid state relay control set as dig out on FIO4 - (Channel = relay) logic low = off (0), Logic High = On (1) What i would like to do is power a heater using the SSR but use PWM and a PID loop to control the temperature of a box. I.e Vary the power to the heater by PWM of the SSR which in turn is controlled by a PID loop with the Temp probe and a temperature setpoint. Thanking you in advance! Best regards Rich
  2. I'm trying to use the PID to control a SSR. It needs to turn the SSR on and off based off of a Temp process variable. I have the PID Output Channel set to PIDOut. I then use sequence code to either send a 0 or 1 to the SSR channel based off of PIDOut. When I click on SSR channel and look at the values in the table, I can get it to alternate between 0 and 1, as it should by changing the set point in the PID. The SSR channel is in DAC0 and the corresponding Vs, but the SSR remains powered. It will not turn off with a value of 0. What am I doing wrong?
  3. I am planning to use a proportional electro-hydraulic pressure regulator to adjust the pressure within a leak test system to a point set in a DAQFactory based user interface. The PID loop will control the system but we require the maximum response time to be down to less than a second. The regulator its-self is capable of doing this but will i be able to do this within the software or are the DAQFactory PID contrrollers meant for much larger timescales. Cheers