ahmed_abdou Posted June 9, 2006 Share Posted June 9, 2006 i want to know how to make analog and dgital input &output by daqfactory using labjack u12 i want to make PID controller to dc motor by daqfactory using labjack u12 Link to comment Share on other sites More sharing options...
AzeoTech Posted June 9, 2006 Share Posted June 9, 2006 For your first question concerning analog and digital input and output, please review the guided tour. There is a generic one included in the DAQFactory help, and more LabJack specifics towards the end of that help file. As for your second question, you could try and do PID control with a U12, but with its 16ms latency, the control would not be very tight. With DAQFactory, your best bet is to use DAQFactory Base or higher which has built in PID loop control. How it applies to your application depends. I would need more detail about your hardware setup to even begin to address it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.