Problem with Modbus Status Coil.

Recommended Posts

Dear Sirs

working with the trial version of Daqfactory THE FOLLOWING observe today.

I'm using the Modbus RTU protocol to 9600-n-8-1.

and I connect to a PLC Koyo DL-06

the point is that I can only read 16 bit using the function status


Read Coil Status (1), but more interesting is that when I load an application

azeotech owner if it works, what will the solution nesecito read 24

bits from 0 to 24 thanks in advance

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.