Alarm reset


Recommended Posts

I send a group of alarm bits to DAQConnect in a word, then decode the individual bits to recover specific alarm conditions. That part is working fine. I have them configured to automatically reset. When an alarm occurs for an extended period of time, it appears that DAQConnect fires, resets, then fires again, creating a series of new alarms. It repeats this on essentially the same timing as the data updates (fire on one, reset on the next, etc.). I would have expected the alarm to remain fired until an update had that bit clear, then reset, creating one alarm. I suspect that requiring manual reset might solve this, but I would prefer to reset automatically. Any suggestions on how to change this?

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.