fboth Posted August 17, 2020 Share Posted August 17, 2020 Hi I use DAQFactory since 15 or more years with many Digital inputs and Outputs. Now I try on another computer with your trial software to control a stepper motor. For this I want to set digital outputs. I started this simple program to test the SMD controller, but the digital output does not stay on it goes always off after 1 second or so not after 5 seconds and I could not find out what I am doing wrong. I even tested a second LJ U12. //to test the stepper motor //endwhile Quote Link to comment Share on other sites More sharing options...
AzeoTech Posted August 17, 2020 Share Posted August 17, 2020 I would need to see your actual .ctl document. My first guess is that you have a channel with Timing, but I would have to see the whole doc to confirm. Quote Link to comment Share on other sites More sharing options...
fboth Posted August 18, 2020 Author Share Posted August 18, 2020 Hi Guru, many thanks yes it was just this? Good service form you as always Thanks a lot Franz Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.