Sign in to follow this  
Guest Mr_Fox

Start/Stop Stream based on input state

Recommended Posts

Guest Mr_Fox

I am trying to set up a routine that scans 2 analog channels with single readouts at about 0.1 s interval, and waits for a certain threshold to reach. (so far that works fine) then it starts a stream of 2 channels, (about 100-300 samples per second is ok), and keeps waiting for another value to reach (also works fine to this point). then the stream should be stopped. i set up all the channels for start/stop etc like in the FAQ, but DAQFactory always hangs when it should stop the stream, or gives me a message "error in the stream" but only if the stopstream command is inside a sequence or event tab. when i assign it to a buttons quick sequence and press the button it works just fine (hangs only short moment)... any idea how to solve this? i have been trying for 2 days now and DAQFactory is crashing after almost every attempt, or after i get the error message, the menus are all weird so i have to restart it frequently. Very annoying.

I hope you guys know a solution for this :(

Share this post


Link to post
Share on other sites

First question is are you using the U12 or the UE9 with your application?

If you would like to send your file to support@azeotech.com I would be happy to take a look at it to see if I can troubleshoot it for you.

Share this post


Link to post
Share on other sites
Guest Mr_Fox
First question is are you using the U12 or the UE9 with your application?

If you would like to send your file to support@azeotech.com I would be happy to take a look at it to see if I can troubleshoot it for you.

its the U12. i'll send the file now.

regards

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this