Paul

Members
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Paul

  • Rank
    Newbie
  1. Thank you Guru. I have emailed a couple of sample files to support. Regards Paul
  2. Interesting. Just for the heck of it I decided to search for the TriLogi.dll file and came across it in a zip file attached to a posting in this forum back a few years. I extracted the contents (trilogi.dll and trilogi.dds) and copied them into the root directory of the DAQFactory installation (C:\Program Files\DAQFactory\ in my case). I restarted DAQFactory Express, loaded my project and now the TriLogi.dll error is gone but I am getting another message about a missing dll. See below: C1033 Unable to load device driver RFScada.dll, check file path and make sure manufacturer's drivers are installed. I have uninstalled DAQFactory and re-installed with the same results with the errors. I am running on Windows 7 SP1, 32-bit. Thank you for describing what the initcomm() call does. It makes sense and explains the behaviour I observe. I can email the project file if required. What email address should I use? Thanks Paul
  3. Thank you for your comments and suggestions. I will look at trying to implement reading data programmatically rather than using a channel later. Exploring the problem further, I have removed the channel so that now the project only contains the MODBUS RTU RS485 device I created from scratch for the Shimaden SRS11A temperature controller and a script to check for errors on the RS485 connection using OnAlert(). I still find I am getting an error perhaps 2 in every 3 times I launch the project describing the following: "C1033 Unable to load device driver TriLogi.dll, check file path and make sure manufacturer's drivers are installed." To my knowledge I am not doing anything which would require the TriLogi.dll file. Perhaps my installation of DAQFactory is corrupt? I can't locate TriLogi.dll on my computer. Is this file supposed to be included with a default DAQFactory installation? Do I really need this file or does it point to another problem? Does the mydevice.initcomm() call limit itself to checking whether the COM port (in this case) configured in the RS485 device is active and responding or does it also somehow check there is a RS485 device connected to it? Thanks in advance. Paul
  4. I have just started using DAQFactory and now DAQFactory Express (both Release 17.1 Build 2309) for monitoring a temperature controller via RS485/Modbus. I am impressed with DAQFactory (thanks to the developers for such a great product) and am slowly getting an understanding of how to use it after lots of attempts, reading and searching of the forum. I have been able to configure a new RS485/Modbus device in DAQFactory and successfully connect using a USB-Serial adapter to a Shimaden SRS11A temperature controller and retrieve the current temperature value. I have also configured a single channel and a logging set which work well. I am trying to add some error handling to manage serial port errors on the RS485/Modbus connection such as when the RS485/Modbus device is powered off, the USB-Serial adapter is not plugged into the computer, or a RS485/Modbus timeout. I am using the OnAlert() function to deal with these types of errors as they are not caught by using the Try/Catch approach in scripts/sequences. This is catching errors/alerts OK except I am observing inconsistent behaviour. I have an auto-start sequence called Main which sets the Channel timing to zero then does a device...initcomm() to see if communication is working. When I setup a test scenario where the USB-serial adapter is connected but the RS485/Modbus device is powered off, I sometimes get a timeout error, no error or an occasional error where DAQFactory cannot load the driver TriLogi.dll (I am not using this driver, my device is using the supplied ModbusRTU one). The fault is probably something I have or haven't done but I was wondering whether anyone has seen something like this before? Any help or suggestions are welcome. Thanks Paul