kontodimos Posted May 3, 2009 Share Posted May 3, 2009 Hello, my question is about low frequency measurement with rising edges (Mode 2). Everything works fine and the values I'm getting for the water flow are correct. But I have a tiny-big problem. When there is no flow the value of the timer is the last one and stays like that. Meaning that when I really have 0 Hz it keeps show me the last updated value e.g 10 Hz. How can I make it understund that there is no flow? Using Labjack U3 Thanks in advance Link to comment Share on other sites More sharing options...
AzeoTech Posted May 3, 2009 Share Posted May 3, 2009 DAQFactory calls directly into the LabJack UD for this measurement, so I'm afraid you'll have to ask the folks at LabJack (www.labjack.com) why its returning the same value. Link to comment Share on other sites More sharing options...
kontodimos Posted May 3, 2009 Author Share Posted May 3, 2009 Thank you for the instant reply! I will aske them but I thought it might be a software solution Thanks again Link to comment Share on other sites More sharing options...
AzeoTech Posted May 3, 2009 Share Posted May 3, 2009 It may be a missing setting, but I don't know. As I said, we pass through most everything to their driver so that when they add new features or new devices (like the U6) we instantly support it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.