EA1 Posted February 2, 2013 Share Posted February 2, 2013 I seem to have a problem with DaqFactory recognizing a 2nd U3-HV LabJack that I am trying to install. The intial set-up had the single LabJack as Device #0. With the second LabJack, using LJControl, I assigned numbers 1 and 2 to the original and new LJ. I reassigned Device #0 channels to #1 in the ctl program, and that worked fine. However, I could not address the 2nd device. The error was that the device could not be found (or was not recognized). Is there something I missed in the configuration? I had thought the 2nd LJ would be identified automatically. Thanks. Link to comment Share on other sites More sharing options...
AzeoTech Posted February 2, 2013 Share Posted February 2, 2013 You will likely need to restart DAQFactory after renumbering your D#0's to D#1. Its probable that the D#0's connected to the 2nd device and locked you out from accessing it with D#2. A restart with no mention of D#0 in your app should resolve it. Link to comment Share on other sites More sharing options...
EA1 Posted February 2, 2013 Author Share Posted February 2, 2013 Thanks. I think the whole computer needed to be rebooted too to load the driver on LJ#2. In any event, all is good now. Link to comment Share on other sites More sharing options...
AzeoTech Posted February 4, 2013 Share Posted February 4, 2013 Reboot and power cycle are the two most common fixes for any computer / hardware problem Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.